地学前缘 ›› 2010, Vol. 17 ›› Issue (4): 262-269.

• 论文 • 上一篇    下一篇

用于MC-ICP-MS测定环境样品中铜、锌同位素的化学分离方法

梁莉莉,刘丛强,王中良,朱祥坤,宋柳霆,李津,唐索寒   

  1. 1中国地质大学(武汉)环境学院, 湖北 武汉 430074
    2中国科学院 地球化学研究所环境地球化学国家重点实验室, 贵州 贵阳 550002
    3国土资源部 同位素重点实验室; 中国地质科学院 地质研究所, 北京 100037
  • 收稿日期:2010-03-09 修回日期:2010-03-31 出版日期:2010-07-01 发布日期:2010-07-01
  • 作者简介:梁莉莉(1980—),女,博士,讲师,主要从事同位素地球化学研究。Email: lianglili@vip.gyig.ac.cn
  • 基金资助:

    国家自然科学青年基金项目(40903005);中国科学院创新团队国际合作伙伴计划;国家自然科学基金重点项目(90610037);“西部之光”项目(20051404)

Chromatographic separation of Cu and Zn from environmental samples for determination of isotopic composition by MC-ICP-MS.

 LIANG  Chi-Chi, LIU  Cong-Jiang, WANG  Zhong-Liang, SHU  Xiang-Kun, SONG  Liu-Ting, LI  Jin, TANG  Suo-Han   

  1. 1.School of Environmental Studies, China University of Geosciences(Wuhan), Wuhan 430074, China
    2.State Key Laboratory of Environmental Geochemistry, Institute of Geochemistry, Chinese Academy of Science, Guiyang  550002, China
    3.Key Laboratory of Isotopic Geology, Ministry of Land and Resources; Institute of Geology, Chinese Academy of Geological Sciences, Beijing 100037, China
  • Received:2010-03-09 Revised:2010-03-31 Online:2010-07-01 Published:2010-07-01

PDF (PC)

904

摘要：

对不同离子交换柱、淋洗体积、盐度、分离次数等一系列影响铜、锌纯化分离效果的条件进行了探讨,确定了环境样品(湖泊沉积物、植物和颗粒物)中铜、锌同位素测定时化学分离的最佳条件。采用AG MP1(100~200目)阴离子交换树脂,以7 mol/L HCl+0001％ H2O2、2 mol/L HCl+0001％ H2O2、05 mol/L HNO3作为淋洗液,分别在适当的体积接收淋洗液,可以有效地分离沉积物、植物和悬浮物等样品中的铜和锌。化学分离过程中Cu和Zn的回收率接近100％,同位素分馏在测试误差范围以内。将此方法应用于对红枫湖和阿哈湖水体悬浮物、植物和鱼类等样品中Cu、Zn的分离,经MC-ICP-MS测试后,准确获得了这些样品的Cu、Zn同位素组成。

关键词: 铜、锌同位素, 离子交换, 淋洗体积, 分离效果

Abstract:

The factors influencing chromatographic separation of Cu and Zn from environmental samples (sediment, plant and suspended particulate material), such as resin column, elution volume, salinity and separation times were experimentally studied, and the optimal conditions of separating Cu and Zn from environmental samples were decided. AG MP1 resin (100200 mesh) was used as anion exchange resin and 7 mol/L HCl + 0.001% H2O2, 2 mol/L HCl+ 0.001% H2O2, 0.5 mol/L HNO3 were used as eluants, and then the eluants were collected at fitting volume respectively. This procedure can separate Cu and Zn effectively from sediment, plant, and suspended particulate matter (SPM) samples, the yield of which is close to 100%, and the isotope fractionation during which is small enough to be neglected. This method was successfully applied to the separation of Cu and Zn from the sediment, plant and suspended particulate materials in Hongfeng and Aha Lakes, and the δ65Cu and δ66Zn values of those samples were measured exactly by MCICPMS.

Key words: copper and zinc isotope, ion exchange, volume of elution; , separate result

中图分类号: